LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 LE, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Service Information) (Except Hybrid) >> Seat Position Sensor >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    Refer to PRECAUTION [12/2012 - ]

    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Refer to PRECAUTION [12/2012 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2012 - 10/2015] Refer to INITIALIZATION [10/2015 - 08/2016] Refer to INITIALIZATION [08/2016 - ]

  3. REMOVE FRONT SEAT ASSEMBLY LH 
    1. for Manual Seat:

      Refer to REMOVAL [12/2012 - 08/2016] Refer to REMOVAL [08/2016 - ]

    2. for Power Seat:

      Refer to REMOVAL [12/2012 - ]

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat) 

    Refer to PROCEDURE - Step 1 Refer to PROCEDURE - Step 1

  5. REMOVE VERTICAL ADJUSTING HANDLE LH (for Manual Seat) 

    Refer to PROCEDURE - Step 2 Refer to PROCEDURE - Step 2

  6. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat) 

    Refer to PROCEDURE - Step 3 Refer to PROCEDURE - Step 3

  7. REMOVE SEAT POSITION AIRBAG SENSOR 
    1. for Manual Seat:
      GTY377174Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the connector.
      2. Separate the wire harness from the seat slide position sensor protector.
      3. Separate the wire harness from the seat slide position sensor protector.
      4. Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor with the seat slide position sensor protector.
    2. for Power Seat:
      GTY361473Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the connector.
      2. Separate the wire harness from the seat slide position sensor protector.
      3. Separate the wire harness from the seat slide position sensor protector.
      4. Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor with the seat slide position sensor protector.
    3. Remove the seat position airbag sensor from the seat slide position sensor protector as shown in the illustration.
      GTY216780Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals