Installation [12/2012 - ]: Procedure

INSTALL FRONT SEAT AIRBAG ASSEMBLY LH
1. Install the front seat airbag assembly LH with 2 new nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  WARNING:
  - The nuts must not be reused.
  - Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
2. Attach the 2 clamps to the front seatback frame sub-assembly.
INSTALL SEPARATE TYPE FRONT SEATBACK PAD
Refer to PROCEDURE - Step 15 Refer to PROCEDURE - Step 15 Refer to PROCEDURE - Step 15
INSTALL SEPARATE TYPE FRONT SEATBACK COVER
Refer to PROCEDURE - Step 17 Refer to PROCEDURE - Step 17 Refer to PROCEDURE - Step 17
INSTALL FRONT SEAT HEADREST SUPPORT
Refer to PROCEDURE - Step 18 Refer to PROCEDURE - Step 18 Refer to PROCEDURE - Step 18
INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Refer to PROCEDURE - Step 19 Refer to PROCEDURE - Step 19 Refer to PROCEDURE - Step 19
INSTALL FRONT INNER SEAT CUSHION SHIELD LH
Refer to PROCEDURE - Step 20 Refer to PROCEDURE - Step 20 Refer to PROCEDURE - Step 20
INSTALL FRONT SEAT CUSHION SHIELD LH
Refer to PROCEDURE - Step 25 Refer to PROCEDURE - Step 26 Refer to PROCEDURE - Step 26
INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD
Refer to PROCEDURE - Step 26 Refer to PROCEDURE - Step 27 Refer to PROCEDURE - Step 27
INSTALL FRONT SEAT ASSEMBLY LH
Refer to INSTALLATION [12/2012 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [12/2012 - 10/2015] Refer to INITIALIZATION [10/2015 - 08/2016] Refer to INITIALIZATION [08/2016 - ]
PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [12/2012 - ]
CHECK SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM [12/2012 - ]