LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 LE, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Service Information) (Except Hybrid) >> FRONT SEAT SIDE AIRBAG ASSEMBLY (for Manual Seat) >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    Refer to PRECAUTION [12/2012 - ]

    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Refer to PRECAUTION [12/2012 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2012 - 10/2015] Refer to INITIALIZATION [10/2015 - 08/2016] Refer to INITIALIZATION [08/2016 - ]

  3. REMOVE FRONT SEAT ASSEMBLY LH 

    Refer to REMOVAL [12/2012 - 08/2016] Refer to REMOVAL [08/2016 - ]

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH 

    Refer to PROCEDURE - Step 1 Refer to PROCEDURE - Step 1

  5. REMOVE VERTICAL ADJUSTING HANDLE LH 

    Refer to PROCEDURE - Step 2 Refer to PROCEDURE - Step 2

  6. REMOVE FRONT SEAT CUSHION SHIELD LH 

    Refer to PROCEDURE - Step 3 Refer to PROCEDURE - Step 3

  7. REMOVE FRONT INNER SEAT CUSHION SHIELD LH 

    Refer to PROCEDURE - Step 4 Refer to PROCEDURE - Step 5

  8. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY 

    Refer to PROCEDURE - Step 6 Refer to PROCEDURE - Step 6

  9. REMOVE FRONT SEAT HEADREST SUPPORT 

    Refer to PROCEDURE - Step 7 Refer to PROCEDURE - Step 7

  10. REMOVE SEPARATE TYPE FRONT SEATBACK COVER 

    Refer to PROCEDURE - Step 8 Refer to PROCEDURE - Step 8

  11. REMOVE SEPARATE TYPE FRONT SEATBACK PAD 

    Refer to PROCEDURE - Step 10 Refer to PROCEDURE - Step 10

  12. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH 
    1. Detach the 2 clamps from the front seatback frame sub-assembly.
      WARNING:
      • The nuts must not be reused.
      • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
      GTY383934Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 nuts and front seat airbag assembly LH.
scientia non olet · About LEMON Manuals