DTC P2118: Throttle Actuator Control Motor Current Range / Performance [12/2013 - 11/2016]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Data List / Gas Throttle / +BM Voltage.

   Powertrain > Engine > Data List 

   Tester Display
   +BM Voltage

5. Read the value displayed on the Techstream.

   Result	Proceed to
   Less than 4 V	A
   11 to 14 V	B

Result: 

B 

CHECK FOR INTERMITTENT PROBLEMS. 

Refer to  CHECK FOR INTERMITTENT PROBLEMS [12/2013 - 11/2016] 

Result: 

A 

See step  2

1. Disconnect the ECM connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   C1-60 (+BM) - Body ground	Always	11 to 14 V

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C1-59 (ME01) - Body ground	Always	Below 1 Ω
   C1-49 (E1) - Body ground	Always	Below 1 Ω

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. 

Refer to  REMOVAL [12/2013 - 11/2016] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR