Installation [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL BRAKE PEDAL PAD
1. Install the brake pedal pad to the brake pedal support assembly.
INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
1. Install the brake pedal support assembly with the 4 nuts.
  Torque: 12.7 N*m (130 kgf*cm, 9 ft.*lbf)
2. Install the brake pedal support assembly to the instrument panel reinforcement assembly with the 2 bolts.
  Torque: 35 N*m (357 kgf*cm, 26 ft.*lbf)
3. Engage the wire harness clamp.

INSTALL PUSH ROD PIN

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Lithium Soap Base Glycol Grease

Apply lithium soap base glycol grease to the push rod pin.

Connect the master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.

NOTE:

Be sure to install the push rod pin in the correct direction.

INSTALL BRAKE PEDAL RETURN SPRING

Install the brake pedal return spring to the instrument panel reinforcement assembly and brake pedal support assembly as shown in the illustration.

INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
INSTALL STOP LIGHT SWITCH ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY
Refer to PROCEDURE - Step 2
INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to INSTALLATION [02/2014 - ]
INSPECT AND ADJUST BRAKE PEDAL
Refer to ADJUSTMENT [02/2014 - ]