LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 68 (Steering Column (Service Information) (Hybrid)) >> Steering Wheel >> Installation [02/2014 - ] >> Procedure

Installation [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL STEERING SHAKE DAMPER 
    1. Install the steering shake damper to the steering wheel assembly with the 2 screws.

      Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf) 

  2. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater) 

    See step  1

  3. INSTALL CRUISE CONTROL MAIN SWITCH 

    Refer to PROCEDURE - Step 1

  4. INSTALL CRUISE CONTROL SWITCH WIRE 
    1. Install the cruise control switch wire.
  5. INSTALL STEERING PAD SWITCH ASSEMBLY 

    See step  1

  6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  7. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7 , or refer to PROCEDURE - Step 7

  8. INSTALL STEERING WHEEL ASSEMBLY 
    1. GTY443828Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

    2. Install the steering wheel assembly set nut.

      Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf) 

    3. w/ Steering Heater:
      1. Connect the connector to the steering wheel heater control assembly.
    4. Connect each connector to the spiral cable with sensor sub-assembly.
  9. CHECK STEERING WHEEL CENTER POINT 
  10. INSTALL HORN BUTTON ASSEMBLY 

    Refer to INSTALLATION [02/2014 - 11/2016] , or refer to INSTALLATION [11/2016 - ]

scientia non olet · About LEMON Manuals