LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Cooling System (1AR-FE) (Service Information) (Except Hybrid)) >> Water Pump >> Installation [12/2013 - ] >> Procedure

Installation [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL ENGINE WATER PUMP ASSEMBLY 
    1. Install a new water pump gasket and the engine water pump assembly with the 7 bolts.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

  2. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY 

    Refer to PROCEDURE - Step 50 , or refer to PROCEDURE - Step 50

  3. INSTALL GENERATOR ASSEMBLY 

    Refer to INSTALLATION [12/2013 - ]

  4. ADD ENGINE COOLANT 

    See step  2 , or see step  2

  5. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

scientia non olet · About LEMON Manuals