Removal [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION
Refer to PRECAUTION [02/2014 - 11/2016] Refer to PRECAUTION [11/2016 - ]

NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [02/2014 - 11/2016] Refer to PRECAUTION [11/2016 - ]
REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 1 Refer to PROCEDURE - Step 1 Refer to PROCEDURE - Step 1
REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 2 Refer to PROCEDURE - Step 2 Refer to PROCEDURE - Step 2
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [02/2014 - 11/2016] Refer to INITIALIZATION [11/2016 - ]
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY
Refer to PROCEDURE - Step 22
REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 23
REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
Refer to PROCEDURE - Step 24
REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
Refer to PROCEDURE - Step 25
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
Refer to PROCEDURE - Step 5
REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)
Refer to PROCEDURE - Step 8

REMOVE CLOCK ASSEMBLY

Remove the 2 screws.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the 2 claws.

Disconnect the connector and remove the clock assembly.