LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 52 (Audio / Video System (Service Information) (Hybrid)) >> Radio Receiver >> Removal [02/2014 - ] >> Procedure

Removal [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 22

  2. REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 23

  3. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 24

  4. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 25

  5. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET 
    1. Remove the 4 bolts.
      GTY432141Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the radio receiver assembly with bracket toward the rear of the vehicle and disengage the 2 claws and 2 clips.
      GTY432142Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect each connector and remove the radio receiver assembly with bracket.
  6. REMOVE STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio) 

    See step  10

  7. REMOVE NO. 1 RADIO RECEIVER BRACKET 
    1. Remove the 3 screws and No. 1 radio receiver bracket.
      GTY431933Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE NO. 2 RADIO RECEIVER BRACKET 
    1. Remove the 3 screws and No. 2 radio receiver bracket.
      GTY431934Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY 
scientia non olet · About LEMON Manuals