LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 95 (Engine Control System (2GR-FXE) (Service Information) (Hybrid)) >> Engine Coolant Temperature Sensor >> Removal [02/2014 - 11/2016] >> Procedure

Removal [02/2014 - 11/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY 

    Refer to REMOVAL [02/2014 - ]

  2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3 , or refer to PROCEDURE - Step 3

  3. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 22 , or refer to PROCEDURE - Step 22

  4. REMOVE RADIATOR SIDE DEFLECTOR SEAL LH 

    Refer to PROCEDURE - Step 1

  5. REMOVE RADIATOR SIDE SEAL RH 

    Refer to PROCEDURE - Step 2

  6. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 3

  7. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 2

  8. REMOVE INLET NO. 2 AIR CLEANER 

    See step  9

  9. REMOVE INLET NO. 1 AIR CLEANER 

    See step  10

  10. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    See step  11

  11. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
      GTY444085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 19 mm union nut wrench, remove the engine coolant temperature sensor from the water outlet.
      NOTE:

      If the engine coolant temperature sensor has been struck or dropped, replace it.

    3. Remove the gasket from the engine coolant temperature sensor.
scientia non olet · About LEMON Manuals