Replacement [12/2013 - 11/2016]: Procedure

Refer to PROCEDURE - Step 8

Refer to PROCEDURE - Step 11

Refer to PROCEDURE - Step 13

1. Remove the refill plug and gasket from the automatic transaxle assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle oil pan sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle oil pan sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	No. 1 Transmission Oil Filler Tube
   *a	Hexagon Socket Wrench
   *b	Overflow Plug Hole

4. Drain automatic transaxle fluid from the automatic transaxle assembly.
5. Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle oil pan sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	No. 1 Transmission Oil Filler Tube
   *a	Hexagon Socket Wrench
   *b	Overflow Plug Hole

   Torque: 1.7 N*m (17 kgf*cm, 15 in.*lbf) 

6. Using a 6 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the automatic transaxle oil pan sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.

7. Temporarily install the gasket and refill plug to the automatic transaxle assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.

Refer to REMOVAL [12/2013 - 11/2016]

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, remove the transaxle case oil seal LH from the automatic transaxle assembly.
   • SST: 09308-00010 
   NOTE:

   Be careful not to damage the transaxle case sub-assembly.

1. Using SST and a hammer, install a new transaxle case oil seal LH to the automatic transaxle assembly.
   • SST: 09316-10010 
   • SST: 09950-70010 
     1. 09951-07100

   Standard Depth

   -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Make sure that the transaxle case oil seal LH is installed in the correct direction.
   • Do not damage the transaxle case oil seal LH lip.
2. Coat the lip of the transaxle case oil seal LH with MP grease.

Refer to INSTALLATION [12/2013 - 11/2016]

Refer to ADJUSTMENT [12/2013 - 11/2016]

Refer to PROCEDURE - Step 90

Refer to PROCEDURE - Step 92

Refer to PROCEDURE - Step 96