Removal [12/2013 - 11/2016]: Procedure

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 25

1. Disconnect the mass air flow meter sub-assembly connector and disengage the wire harness clamp.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Slide the clip and disconnect the No. 2 ventilation hose from the No. 1 air cleaner hose.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Disengage the vacuum hose clamp from the No. 1 air cleaner hose.
4. Disconnect the air hose from the air cleaner cap sub-assembly.
5. Disengage the 2 air cleaner cap clamps.
6. Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the throttle body with motor assembly connector and disengage the wire harness clamp.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Slide the 2 clips and disconnect the No. 2 water by-pass hose and No. 3 water by-pass hose from the throttle body with motor assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	No. 2 water by-pass hose
   *2	No. 3 water by-pass hose

3. Remove the 4 bolts, wire harness clamp bracket and throttle body with motor assembly from the intake air surge tank.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   If the throttle body with motor assembly has been struck or dropped, replace it.

1. Remove the throttle body gasket from the intake air surge tank.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002