LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Service Information) (Hybrid) >> SRS Seat Cushion Airbag Assembly >> Removal [02/2014 - 11/2016] >> Procedure

Removal [02/2014 - 11/2016]: Procedure

  1. REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat) 

    Refer to REMOVAL [02/2014 - 11/2016]

  2. REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat) 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to REMOVAL [02/2014 - ]

  3. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER RH (for Manual Seat) 

    Refer to PROCEDURE - Step 4

  4. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER RH (for Power Seat) 

    HINT: 

    Use the same procedure as for the LH side.

    w/o Climate Control Seat System: Refer to PROCEDURE - Step 6

    w/ Climate Control Seat System: Refer to PROCEDURE - Step 7

  5. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH (for Manual Seat) 

    Refer to PROCEDURE - Step 5

  6. REMOVE FRONT SEAT CUSHION SHIELD RH 

    for Manual Seat: Refer to PROCEDURE - Step 6

    for Power Seat: Refer to PROCEDURE - Step 11

  7. REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD RH (for Power Seat) 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 12

  8. REMOVE FRONT SEAT INNER CUSHION SHIELD RH 

    for Manual Seat: Refer to PROCEDURE - Step 7

    for Power Seat: Refer to PROCEDURE - Step 9

  9. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH (for Manual Seat) 

    Refer to PROCEDURE - Step 8

  10. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH (for Power Seat) 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 19

  11. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD RH 

    for Manual Seat: Refer to PROCEDURE - Step 16

    for Power Seat: Refer to PROCEDURE - Step 30

  12. REMOVE FRONT SEAT AIRBAG SUB-ASSEMBLY RH 
    WARNING:

    When storing the front seat airbag sub-assembly RH, keep the airbag deployment side facing upward.

    1. for Manual Seat:
      1. Separate the front seat airbag sub-assembly RH wire harness from the seat clamp.
        GTY440116Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        Seat Clamp
      2. Disengage the claw and 3 clamps.

        HINT: 

        Disengage the 3 clamps first.

    2. for Power Seat:
      1. GTY449436Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        Seat Clamp

        Separate the front seat airbag sub-assembly RH wire harness from the seat clamp.

      2. Disengage the claw and 3 clamps.

        HINT: 

        Disengage the 3 clamps first.

    3. Remove the 3 nuts and front seat airbag sub-assembly RH.
      GTY431907Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      WARNING:
      • The nuts must not be reused.
      • Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.
scientia non olet · About LEMON Manuals