Installation [02/2014 - 11/2016]: Procedure

INSTALL FRONT SEAT AIRBAG SUB-ASSEMBLY RH
1. Install the front seat airbag sub-assembly RH with 3 new nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  WARNING:
  - The nuts must not be reused.
  - Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.
2. Engage the claw and 3 clamps.
  HINT:
  
  Engage the claw first.
3. Install the front seat airbag sub-assembly RH wire harness to the seat clamp.
INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD RH
for Manual Seat: Refer to PROCEDURE - Step 10

for Power Seat: Refer to PROCEDURE - Step 17
INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH (for Manual Seat)
Refer to PROCEDURE - Step 18
INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH (for Power Seat)
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 27
INSTALL FRONT SEAT INNER CUSHION SHIELD RH
for Manual Seat: Refer to PROCEDURE - Step 19

for Power Seat: Refer to PROCEDURE - Step 38
INSTALL FRONT SEAT INNER NO. 1 CUSHION SHIELD RH (for Power Seat)
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 34
INSTALL FRONT SEAT CUSHION SHIELD RH
for Manual Seat: Refer to PROCEDURE - Step 20

for Power Seat: Refer to PROCEDURE - Step 36
INSTALL RECLINING ADJUSTER RELEASE HANDLE RH (for Manual Seat)
Refer to PROCEDURE - Step 21
CONNECT SEPARATE TYPE FRONT SEATBACK COVER RH (for Manual Seat)
Refer to PROCEDURE - Step 22
CONNECT SEPARATE TYPE FRONT SEATBACK COVER RH (for Power Seat)
HINT:

Use the same procedure as for the LH side.

w/o Climate Control Seat System: Refer to PROCEDURE - Step 39

w/ Climate Control Seat System: Refer to PROCEDURE - Step 40
INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)
Refer to INSTALLATION [02/2014 - 11/2016]
INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)
HINT:

Use the same procedure as for the LH side.

Refer to INSTALLATION [02/2014 - 11/2016]
PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [02/2014 - ]