Installation [02/2014 - 11/2016]: Procedure

INSTALL FRONT SEAT AIRBAG ASSEMBLY
1. Install the front seat airbag assembly with 2 new nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  WARNING:
  - The nuts must not be reused.
  - Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.
2. Engage the 2 clamps.
INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
for Manual Seat: Refer to PROCEDURE - Step 16

for Power Seat: Refer to PROCEDURE - Step 25
INSTALL FRONT SEAT HEADREST SUPPORT ASSEMBLY
for Manual Seat: Refer to PROCEDURE - Step 17

for Power Seat: Refer to PROCEDURE - Step 26
INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
for Manual Seat: Refer to PROCEDURE - Step 18

for Power Seat: Refer to PROCEDURE - Step 27
INSTALL FRONT SEAT INNER CUSHION SHIELD (for Manual Seat)
Refer to PROCEDURE - Step 19
INSTALL FRONT SEAT INNER CUSHION SHIELD (for Power Seat)
for Driver Side: Refer to PROCEDURE - Step 37

for Front Passenger Side: Refer to PROCEDURE - Step 38
INSTALL FRONT SEAT INNER NO. 1 CUSHION SHIELD (for Power Seat)
Refer to PROCEDURE - Step 34
INSTALL FRONT SEAT CUSHION SHIELD (for Manual Seat)
Refer to PROCEDURE - Step 20
INSTALL FRONT SEAT CUSHION SHIELD (for Power Seat)
for Driver Side: Refer to PROCEDURE - Step 35

for Front Passenger Side: Refer to PROCEDURE - Step 36
INSTALL RECLINING ADJUSTER RELEASE HANDLE (for Manual Seat)
Refer to PROCEDURE - Step 21
CONNECT SEPARATE TYPE FRONT SEATBACK COVER
for Manual Seat: Refer to PROCEDURE - Step 22

for Power Seat without Climate Control Seat System: Refer to PROCEDURE - Step 39

for Power Seat with Climate Control Seat System: Refer to PROCEDURE - Step 40
INSTALL FRONT SEAT ASSEMBLY
for Manual Seat: Refer to INSTALLATION [02/2014 - 11/2016]

for Power Seat: Refer to INSTALLATION [02/2014 - 11/2016]
PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [02/2014 - ]