DTC P0AC0-817: Hybrid Battery Pack Current Sensor Circuit Range / Performance [02/2014 - 11/2016]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check for DTCs.

   Powertrain > Hybrid Control > Trouble Codes 

   Result

   Result	Proceed to
   P0AC0-817 only is output.	A
   P0AFC-123 is output.	B

5. Turn the power switch off.

Result:  2

B 

GO TO DTC CHART (P0AFC-123). Refer to  DTC P0AFC-123: Hybrid Battery Pack Sensor Module [02/2014 - 11/2016] 

Result:  1

A 

See step  2

Refer to COMPONENTS [02/2014 - ]

Result

Result:  1

NEXT 

See step  3

Refer to PROCEDURE - Step 3

Result

Result:  1

NEXT 

See step  4

1. Drive the vehicle for approximately 10 minutes according to the freeze frame data items "Vehicle Spd", "Accelerator Degree", "Power Resource IB", "M(MG2) Trq Exec Val" and "G(MG1) Trq Exec Val".
   WARNING:

   When performing the confirmation driving pattern, obey all speed limits and traffic laws.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  5

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check for DTCs.

   Powertrain > Hybrid Control > Trouble Codes 

   Result

   Proceed to
   P0AC0-817 is not output.
   P0AC0-817 is output again.

5. Turn the power switch off.

Result:  1

P0AC0-817 is not output. 

COMPLETED 

Result:  2

P0AC0-817 is output again. 

REPLACE BATTERY VOLTAGE SENSOR. Refer to  COMPONENTS [02/2014 - ]