LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Hybrid Control System (2GR-FXS) - Diagnostic Codes (2 Of 6)) >> Hybrid Control System >> DTC P0A0F-204: Engine Failed to Start; DTC P0A0F-205: Engine Failed to Start; DTC P0A0F-206: Engine Failed to Start; DTC P0A0F-524: Engine Failed to Start; DTC P0A0F-525: Engine Failed to Start [11/2016 - ] >> Procedure

DTC P0A0F-204: Engine Failed to Start; DTC P0A0F-205: Engine Failed to Start; DTC P0A0F-206: Engine Failed to Start; DTC P0A0F-524: Engine Failed to Start; DTC P0A0F-525: Engine Failed to Start [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC OUTPUT (ENGINE AND ECT) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    4. Check for DTCs.

      Powertrain > Engine and ECT > Trouble Codes 

    5. Turn the power switch off.

      Result

      Proceed to
      NEXT

    Result:  2

    NEXT 

    GO TO DTC CHART (SFI SYSTEM). Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2016 - 10/2017]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2017 - ] 

scientia non olet · About LEMON Manuals