Section 60 (SFI System (2GR-FXS) - Diagnostics - Introduction - (Hybrid) - 2 Of 2)
WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- SFI System
- Data List / Active Test [11/2016 - ]
- Data List / Active Test [11/2016 - ]
- Reference Waveforms For Active Test
- Waveform *3: Control The Injection Volume For A/F Sensor (Engine Warmed Up And Idling, Inspection Mode [Maintenance Mode], Not Charge Control)
- Waveform *4: Control The EGR Step Position (Engine Warmed Up And Idling, Inspection Mode [Maintenance Mode], Not Charge Control)
- Waveform *5: Activate The VSV For EVAP Control (Idling After Warming Up, Direct Injection Control)
- Waveform *6: Control The ETCS Open/Close Fast Speed [Active Test For Electrical Throttle Control System] (Power Switch On (IG), Accelerator Pedal Fully Depressed)
- Waveform *7: Control The VVT Linear (Bank 1) (Idling, Inspection Mode [Maintenance Mode], Not Charge Control)
- Waveform *8: Control The VVT Exhaust Linear (Bank 1) (Idling, Inspection Mode [Maintenance Mode], Not Charge Control)
- Diagnostic Trouble Code Chart [11/2016 - 10/2017]
- Diagnostic Trouble Code Chart [10/2017 - ]
- Data List / Active Test [11/2016 - ]