DTC P3193: Fuel Run Out [02/2014 - 11/2016]: Procedure

1. Check the amount of fuel remaining.

   OK

   There is enough fuel.

   HINT: 

   • DTCs P3190, P3191 and/or P3193 may be output if the vehicle ran out of fuel in the past.
   • If not enough fuel is added, DTC P3190, P3191 or P3193 may be output again. If the engine cannot be started because the vehicle is out of fuel, add fuel until the fuel level warning light turns off.

   Proceed to
   OK
   NG

Result: 

OK 

See step  3

Result: 

NG 

See step  2

1. Add fuel until the fuel level warning light turns off.

Result: 

NEXT 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Engine and ECT > Clear DTCs 

5. Turn the power switch off and wait for at least 30 seconds.
6. Turn the power switch on (READY).
7. Turn the Techstream on.
8. Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
9. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
10. Read the DTCs.

    Refer to DTC CHECK / CLEAR [02/2014 - 11/2016]

    Powertrain > Engine and ECT > Trouble Codes 

    Result	Proceed to
    DTCs are not output	A
    DTC P3190 or P3191 is output	B
    DTC P3190 or P3191 and other DTCs are output	C

Result: 

A 

END 

Result: 

B 

GO TO DTC P3190, P3191. 

Refer to  DTC P3190: Poor Engine Power; DTC P3191: Engine does not Start [02/2014 - 11/2016]  

Result: 

C 

GO TO DTC CHART. 

Refer to  DIAGNOSTIC TROUBLE CODE CHART [02/2014 - 08/2014] 

Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2014 - 11/2015] 

Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2015 - 11/2016]