LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (2GR-FXE) (Service Information) (Hybrid) >> Thermostat >> Installation [02/2014 - 11/2016] >> Procedure

Installation [02/2014 - 11/2016]: Procedure

  1. INSTALL THERMOSTAT 
    1. Install a new gasket to the thermostat.
    2. Install the thermostat to the water inlet housing.
      GTY450523Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Jiggle Valve
      *b 10°

      HINT: 

      The jiggle valve may be set within 10° on either side of the prescribed position.

  2. INSTALL WATER INLET 
    1. Install the water inlet with the 2 nuts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Connect the No. 2 radiator hose and oil cooler pipe and slide the 2 clips to secure them.
  3. INSTALL ECM 

    Refer to INSTALLATION [02/2014 - 11/2016]

  4. INSTALL FRONT FENDER APRON SEAL RH 

    Refer to PROCEDURE - Step 2

  5. INSTALL FRONT FENDER LINER RH 

    Refer to PROCEDURE - Step 3

  6. INSTALL FRONT WHEEL RH 

    Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

  7. ADD ENGINE COOLANT (for Engine) 

    See step  3

  8. INSPECT FOR COOLANT LEAK (for Engine) 

    Refer to PROCEDURE - Step 1

  9. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 68 , or refer to PROCEDURE - Step 67

scientia non olet · About LEMON Manuals