Installation [02/2014 - 11/2016]: Procedure

1. Set the V-ribbed belt onto every pulley.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Engine Water Pump Assembly
   *2	V-ribbed Belt Tensioner Assembly
   *3	Crankshaft Pulley

2. Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.
   NOTE:

   Check that the V-ribbed belt is properly set to each pulley.

3. Check that the V-ribbed belt fits properly in the ribbed grooves.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Correct
   *b	Incorrect

   HINT: 

   Make sure to check by hand that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.

See step   [02/2014 - 11/2015] , or see step   [11/2015 - 11/2016]

1. Install the front fender liner RH with the bolt, 4 screws and 4 clips.

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)