LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake (Service Information) (Hybrid) >> Parking Brake Assembly >> Disassembly [02/2014 - ] >> Procedure

Disassembly [02/2014 - ]: Procedure

  1. DISCONNECT BRAKE BOOSTER PUMP CONNECTOR 

    Refer to PROCEDURE - Step 2

  2. REMOVE REAR WHEEL 
  3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY 

    Refer to PROCEDURE - Step 3

  4. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG 
  5. REMOVE REAR DISC 

    Refer to PROCEDURE - Step 14

  6. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Upper Side) 
    1. Remove the 2 parking brake shoe return tension springs.
      GTY432497Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Be sure to put an identification mark on each parking brake shoe return tension spring so that it can be reinstalled to its original position.

  7. SEPARATE NO. 1 PARKING BRAKE SHOE ASSEMBLY 
    1. Remove the parking brake shoe hold down spring cup and parking brake shoe hold down compression spring to separate the No. 1 parking brake shoe assembly from the backing plate.
      GTY432496Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE PARKING BRAKE SHOE LEVER STRUT 
    1. Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand as shown in the illustration.
      GTY432507Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the parking brake shoe lever strut.
      GTY432493Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE PARKING BRAKE SHOE STRUT COMPRESSION SPRING 
    1. Remove the parking brake shoe strut compression spring.
      GTY432492Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. SEPARATE NO. 2 PARKING BRAKE SHOE ASSEMBLY 
    1. Remove the parking brake shoe hold down spring cup and parking brake shoe hold down compression spring to separate the No. 2 parking brake shoe assembly from the backing plate.
      GTY432490Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET 
    1. Remove the parking brake shoe adjusting screw set.
      GTY432489Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY 
    1. Remove the No. 1 parking brake shoe assembly.
      GTY452291Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side) 
    1. Remove the parking brake shoe return tension spring.
      GTY432491Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. SEPARATE PARKING BRAKE SHOE LEVER 
    1. Using needle-nose pliers, separate the parking brake shoe lever from the No. 3 parking brake cable assembly.
      GTY432485Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Be careful not to damage the No. 3 parking brake cable assembly.

  15. REMOVE PARKING BRAKE SHOE LEVER 
    1. Using a screwdriver, remove the parking brake shoe type C washer, parking brake shoe shim and parking brake shoe lever.
      GTY432484Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Parking brake shoe shims are provided when necessary to adjust the clearance between the parking brake shoe lever and parking brake shoe type C washer. Some vehicles may not be equipped with shims.

  16. REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN 
    1. for Front Side:
      1. Remove the parking brake shoe hold down spring pin.
        GTY432486Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for Rear Side:
      1. Remove the parking brake shoe hold down spring pin.
        GTY432517Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE PARKING BRAKE SHOE GUIDE PLATE 
    1. Remove the parking brake shoe guide plate set bolt and parking brake shoe guide plate.
      GTY432488Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals