LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Corolla S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Continuously Variable Transaxle (Service Information) (Model Code: ZRE172)) >> Oil Cooler >> Removal [08/2013 - ] >> Procedure

Removal [08/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE ENGINE UNDER COVER LH (for 2ZR-FE) 

    Refer to PROCEDURE - Step 6 Refer to PROCEDURE - Step 6

  2. REMOVE ENGINE UNDER COVER LH (for 2ZR-FAE) 

    Refer to PROCEDURE - Step 6 Refer to PROCEDURE - Step 6

  3. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID 

    See step  5

  4. DRAIN ENGINE COOLANT (for 2ZR-FE) 

    Refer to PROCEDURE - Step 1

  5. DRAIN ENGINE COOLANT (for 2ZR-FAE) 

    Refer to PROCEDURE - Step 1

  6. DISCONNECT WATER BY-PASS HOSE ASSEMBLY 
    1. Slide the 2 clips and disconnect the water by-pass hose assembly from the transmission oil cooler.
      GTY432032Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE TRANSMISSION OIL COOLER 
    1. Remove the 3 bolts and transmission oil cooler from the continuously variable transaxle assembly.
      GTY432031Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 O-rings from the transmission oil cooler.
scientia non olet · About LEMON Manuals