LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Avalon XLE >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Service Information) (Except Hybrid) >> Front Seat Side Airbag Assembly >> Installation [10/2014 - ] >> Procedure

Installation [10/2014 - ]: Procedure

  1. INSTALL FRONT SEAT AIRBAG ASSEMBLY 
    WARNING:
    • The nuts must not be reused.
    • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
    1. Install the front seat airbag assembly with 2 new nuts.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

    2. Engage the 2 clamps.
  2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD 

    Refer to PROCEDURE - Step 5

  3. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 27 Refer to PROCEDURE - Step 27

  4. INSTALL FRONT SEAT CUSHION SHIELD (w/o Seat Position Memory System) 

    Refer to PROCEDURE - Step 37 Refer to PROCEDURE - Step 37

  5. INSTALL FRONT SEAT CUSHION SHIELD (w/ Seat Position Memory System) 

    Refer to PROCEDURE - Step 38 Refer to PROCEDURE - Step 38

  6. INSTALL FRONT SEAT INNER CUSHION SHIELD 

    Refer to PROCEDURE - Step 44 Refer to PROCEDURE - Step 44

  7. CONNECT FRONT SEATBACK BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 45 Refer to PROCEDURE - Step 45

  8. INSTALL FRONT SEAT ASSEMBLY 

    (Refer to INSTALLATION [10/2014 - ] )

  9. PERFORM DIAGNOSTIC SYSTEM CHECK 

    (Refer to DTC CHECK / CLEAR [10/2014 - ] )

scientia non olet · About LEMON Manuals