Replacement [08/2015 - 08/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.

DRAIN TRANSFER OIL
Refer to PROCEDURE - Step 1
REMOVE FRONT PROPELLER SHAFT ASSEMBLY
(Refer to REMOVAL [08/2015 - ] )
REMOVE FRONT OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
Refer to PROCEDURE - Step 6
REMOVE FRONT TRANSFER OUTPUT SHAFT COMPANION FLANGE OIL SEAL
Refer to PROCEDURE - Step 7
REMOVE TRANSFER CASE FRONT OIL SEAL

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using SST, tap out the transfer case front oil seal.
  - SST: 09308-00010
  NOTE:
  Be careful not to damage the transfer case front oil seal and front case contact surface.
INSTALL TRANSFER CASE FRONT OIL SEAL

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Coat the lip of a new transfer case front oil seal with MP grease.
2. Using SST and a hammer, tap in the transfer case front oil seal until its metal ring contacts the front case.
  - SST: 09649-17010
  - SST: 09950-70010
    1. 09951-07100
INSTALL FRONT TRANSFER OUTPUT SHAFT COMPANION FLANGE OIL SEAL
Refer to PROCEDURE - Step 54
INSTALL FRONT OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
Refer to PROCEDURE - Step 55
INSTALL FRONT PROPELLER SHAFT ASSEMBLY
(Refer to INSTALLATION [08/2015 - ] )
ADD TRANSFER OIL
Refer to PROCEDURE - Step 2
CHECK FOR TRANSFER OIL LEAK