On-Vehicle Inspection [08/2015 - ]: Procedure
- CHECK TRANSFER OIL
- Remove the filler plug and gasket.
- Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
If the result is not as specified, add transfer oil.
TEXT IN ILLUSTRATION*a 0 to 5 mm NOTE:Too much or too little oil will lead to transfer problems.
- When the oil level is too low, check for oil leaks.
- Install a new gasket to the filler plug and then tighten the plug.
Torque: 37 N.m (377 kgf/cm, 27 ft.lbf)
- Remove the filler plug and gasket.
- ADD TRANSFER OIL
- Remove the filler plug and gasket.
- Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.NOTE:
- Add oil slowly.
- Add oil a little at a time, waiting several minutes between each addition of oil.
HINT:
- Viscosity
SAE 75W
Capacity
1.4 liters (1.5 US qts, 1.2 lmp.qts)
- Wait approximately 5 minutes and check that the oil level has not changed.
- Install a new gasket to the filler plug and then tighten the plug.
Torque: 37 N.m (377 kgf/cm, 27 ft.lbf)