Installation [10/2015 - 08/2017]: Procedure

1. Install the fan shroud with the 2 bolts.

   Torque: 10.5 N*m (107 kgf*cm, 8 ft.*lbf) 

1. Attach the 2 guides and install the cooler condenser assembly.

   Refer to PROCEDURE - Step 1 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 1 [08/2016 - ]

1. Attach the 2 claws to install the No. 2 fan shroud.
2. Install the 2 bolts.

   Torque: 10.5 N*m (107 kgf*cm, 8 ft.*lbf) 

1. Install the 2 lower radiator supports to the fan shroud.

1. Install the water by-pass pipe to the radiator, and slide the hose clamp to secure it.
2. Attach the 3 clamps to install the water by-pass pipe.

1. Install the No. 2 radiator hose to the radiator assembly, and slide the clamp to secure it.

   HINT: 

   Install the hose clamp with the claw facing downward.

1. Install the radiator hose sub-assembly to the radiator assembly and water by-pass pipe, and slide the 2 hose clamps to secure it.

1. Install the radiator assembly together with the fan shroud.
   NOTE:

   Make sure that both lower radiator supports are attached to the fan shroud.

1. Connect the No. 2 water by-pass hose to the radiator assembly, and slide the hose clamp to secure it.

1. Connect the No. 1 water by-pass hose to the water by-pass pipe, and slide the hose clamp to secure it.

See step  3

1. Connect the radiator hose sub-assembly to the cylinder head sub-assembly, and slide the hose clamp to secure it.

1. Install the 2 radiator hose clamps.
2. Connect the No. 8 and No. 9 water by-pass hose to each radiator hose clamp.

1. Install the upper radiator support with the 4 bolts.

   Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

1. Install the 2 No. 1 radiator supports with the 2 bolts.

   Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

1. Connect the 2 cooling fan motor connectors.
2. Attach the 9 wire harness clamps to connect the wire harness.

Refer to PROCEDURE - Step 4 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 4 [08/2016 - ]

Refer to PROCEDURE - Step 5 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 5 [08/2016 - ]

1. Install the radiator upper air guide plate with the 6 clips.

1. Install the front bumper upper reinforcement sub-assembly with the 3 bolts.
2. Install the radiator upper air guide plate with the 2 clips.
3. Connect the horn connector.

1. Attach the clamp to connect the hood lock control cable assembly.

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 7

See step  3

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 4

Refer to PROCEDURE - Step 79

• for Halogen Headlight

  Refer to INSTALLATION [10/2015 - ]

• for LED Headlight

  Refer to INSTALLATION [10/2015 - ]