Installation [10/2014 - ]: Procedure

INSTALL FRONT NO. 1 STABILIZER BAR BUSHING

Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

NOTE:

When installing the front No. 1 stabilizer bar bushings, make sure that the cutout is facing the rear of the vehicle.

INSTALL FRONT STABILIZER BAR
1. Install the front stabilizer bar to the front frame assembly.
INSTALL FRONT NO. 1 STABILIZER BRACKET LH
1. Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.
  Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)
INSTALL FRONT NO. 1 STABILIZER BRACKET RH
HINT:

Perform the same procedure as the LH side.
INSTALL FRONT STABILIZER LINK ASSEMBLY LH
1. Install the front stabilizer link assembly LH to the front stabilizer bar with the nut.
  Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf)
  
  HINT:
  
  If the ball joint turns together with the nut, use a wrench to hold the stud bolt.
INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:

Perform the same procedure as the LH side.
INSTALL FRONT FRAME ASSEMBLY (When Using the Engine Support Bridge)
(See step 14)
INSTALL ENGINE ASSEMBLY WITH TRANSAXLE (When Not Using the Engine Support Bridge)
(Refer to PROCEDURE - Step 14 )