Installation [10/2014 - ]: Procedure

1. Secure the front axle assembly in a vise using aluminum plates.
   NOTE:

   Do not overtighten the vise.

2. Install the front lower ball joint assembly to the front axle assembly with a new nut.

   Torque: 123 N*m (1254 kgf*cm, 91 ft.*lbf) 

   NOTE:

   Prevent oil from adhering to the threaded and tapered parts.

3. Install a new cotter pin.
   NOTE:

   Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.

(Refer to PROCEDURE - Step 6 )