LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belts (Service Information) (Hybrid) >> Front Seat Outer Belt Assembly With Pre-TENSIONER >> Removal [10/2015 - ] >> Procedure

Removal [10/2015 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [10/2014 - ]

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 2

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  4. REMOVE FRONT DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 4

  5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the front door opening trim weatherstrip.
  6. REMOVE REAR DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 8

  7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the rear door opening trim weatherstrip.
  8. REMOVE LAP BELT OUTER ANCHOR COVER 
    1. Disengage the 3 claws to remove the lap belt outer anchor cover.
      GTY375389Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY 
    GTY375388Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
  10. REMOVE CENTER PILLAR LOWER GARNISH 

    Refer to PROCEDURE - Step 12

  11. REMOVE CENTER PILLAR UPPER GARNISH 

    Refer to PROCEDURE - Step 13

  12. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
    GTY375387Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
    2. Using a screwdriver, pull out the locking button to release the lock, and disconnect the pretensioner connector as shown in the illustration.
      GTY565225Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Pretensioner Connector
      *c Locking Button
      *d Release

      HINT: 

      Tape the screwdriver tip before use.

    3. Remove the 2 bolts and front seat outer belt assembly.
      GTY563913Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY 
    1. Remove the 2 bolts.
      GTY375411Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.
scientia non olet · About LEMON Manuals