Installation [10/2014 - ]: Procedure

1. Install the 4 spark plugs.

   Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf) 

   NOTE:

   If a spark plug has been struck or dropped, replace it.

   HINT: 

   • Perform "Inspection After Repair" after replacing a spark plug (Refer to INITIALIZATION [10/2014 - ] ).
   • Install the same parts to their original positions.

1. Install the 4 ignition coil assemblies with the 4 bolts.

   Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

   NOTE:

   If an ignition coil assembly has been struck or dropped, replace it.

   HINT: 

   • Perform "Inspection After Repair" after replacing an ignition coil assembly (Refer to INITIALIZATION [10/2014 - ] ).
   • Install the same parts to their original positions.
2. Connect the 4 ignition coil assembly connectors.

Refer to PROCEDURE - Step 85