LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander LE Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (SFI System [1AR-FE] - Diagnostic Codes - (Except Hybrid) (5 Of 8)) >> SFI System >> DTC P2009: Intake Manifold Runner Control Circuit Low (Bank 1); DTC P2010: Intake Manifold Runner Control Circuit High (Bank 1) [11/2016 - ] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
ALL

Monitor runs whenever the following DTCs are not stored None
P2009

All of the following conditions are met -
Battery voltage 8 V or higher
Starter Off
Output duty cycle 34% or higher
Difference between motor current and previous motor current Less than 0.2 A
P2010

All of the following conditions are met -
Battery voltage 8 V or higher
Starter Off
scientia non olet · About LEMON Manuals