Removal [12/2013 - ]
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work. Refer to PRECAUTION [12/2013 - ] .
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Radio and Display Type with Intuitive Parking Assist System) NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [12/2013 - ] .
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Navigation Receiver Type) NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [12/2013 - ] .
- REMOVE REAR CONSOLE BOX ASSEMBLY
Refer to REMOVAL [08/2013 - ]
- REMOVE BOX BOTTOM MAT . Refer to REMOVAL [12/2013 - ] - Step 25
- REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY . Refer to REMOVAL [12/2013 - ] - Step 26
- REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY . Refer to REMOVAL [12/2013 - ] - Step 23
- REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY . Refer to REMOVAL [12/2013 - ] - Step 24
- REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Radio and Display Type) . Refer to REMOVAL [12/2013 - ] - Step 8
- REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Navigation Receiver Type) . Refer to REMOVAL [12/2013 - ] - Step 8
- REMOVE NO. 1 RADIO BRACKET (for Radio and Display Type) . Refer to REMOVAL [12/2013 - ] - Step 9
- REMOVE NO. 2 RADIO BRACKET (for Radio and Display Type) . Refer to REMOVAL [12/2013 - ] - Step 10
- REMOVE NO. 1 RADIO BRACKET (for Navigation Receiver Type) . Refer to REMOVAL [12/2013 - ] - Step 9
- REMOVE NO. 2 RADIO BRACKET (for Navigation Receiver Type) . Refer to REMOVAL [12/2013 - ] - Step 10
- REMOVE AIR CONDITIONING CONTROL ASSEMBLY (HAZARD SWITCH) . Refer to REMOVAL [12/2013 - ] - Step 15