Engine Unit: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL IGNITION COIL ASSEMBLY . Refer to INSTALLATION - Step 2
INSTALL ENGINE COOLANT TEMPERATURE SENSOR . Refer to INSTALLATION - Step 1
INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY . Refer to INSTALLATION - Step 1
INSTALL KNOCK CONTROL SENSOR . Refer to INSTALLATION - Step 1
INSTALL SENSOR WIRE
1. Install the sensor wire with the bolt.
  
  Fig 1: Identifying Bolt And Knock Control Sensor Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
2. Connect the knock control sensor connector.
INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY . Refer to INSTALLATION - Step 2
INSTALL INTAKE MANIFOLD . Refer to INSTALLATION - Step 5
CONNECT NO. 2 VENTILATION HOSE . Refer to INSTALLATION - Step 9
INSTALL NO. 1 VACUUM SWITCHING VALVE ASSEMBLY . Refer to INSTALLATION - Step 1
INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) . Refer to INSTALLATION - Step 1
INSTALL WATER BY-PASS HOSE
1. Install the No. 1 and No. 2 water by-pass hoses.
  
  Fig 2: Identifying No. 1 And No. 2 Water By-Pass Hoses
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL THROTTLE BODY ASSEMBLY . Refer to INSTALLATION - Step 1
INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET
1. Install the bracket with the 4 bolts.
  
  Fig 3: Identifying No. 1 Compressor Mounting Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
INSTALL EXHAUST MANIFOLD ASSEMBLY . Refer to INSTALLATION - Step 3
INSTALL NO. 2 MANIFOLD STAY . Refer to INSTALLATION - Step 4
INSTALL MANIFOLD STAY . Refer to INSTALLATION - Step 5
INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
1. Apply a light coat of engine oil to a new O-ring.
  
  Fig 4: Identifying Engine Oil Level Dipstick Guide Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the O-ring to the engine oil level dipstick guide.
3. Install the engine oil level dipstick guide with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
4. Install the engine oil level dipstick.