DTC P0AFC-150: Hybrid Battery Pack Sensor Module: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK FUSE (IGCT NO. 3). Refer to PROCEDURE - Step 1
NG → REPLACE FUSE (IGCT NO. 3)

OK: Go to next step
CHECK RELAY (IGCT MAIN). Refer to PROCEDURE - Step 2
NG → REPLACE RELAY (IGCT MAIN)

OK: Go to next step
CHECK HARNESS AND CONNECTOR (IGCT VOLTAGE). Refer to PROCEDURE - Step 3
NG → See step 5

OK → See step 4
REPLACE BATTERY SMART UNIT. Refer to REMOVAL
CHECK HARNESS AND CONNECTOR (BATTERY SMART UNIT - IGCT MAIN RELAY AND BODY GROUND). Refer to PROCEDURE - Step 4
NG → See step 6

OK → CHECK AND REPAIR POWER SOURCE CIRCUIT
CHECK HARNESS AND CONNECTOR (NO. 2 BATTERY PACK WIRE). Refer to PROCEDURE - Step 5
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (NO. 2 BATTERY PACK WIRE)

OK → REPAIR OR REPLACE HARNESS OR CONNECTOR