DTC P2610: ECM / PCM Internal Engine Off Timer Performance: Procedure

WARNING: This page is about a different variant/trim than selected.

REPLACE ECM
1. Replace the ECM, refer to REMOVAL .
NEXT: Go to next step
CHECK WHETHER DTC OUTPUT RECURS (DTC P2610)
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs, refer to DTC CHECK / CLEAR .
5. Turn the ignition switch off.
6. Turn the ignition switch to ON and turn the Techstream on.
7. Start the engine and wait for 10 minutes or more.
8. Enter the following menus: Powertrain / Engine / Trouble Codes / Pending.
9. If no pending DTC is output, the repair has been successfully completed.
NEXT → END