Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL:
| Monitor runs whenever following DTCs not stored | None |
P2111 (THROTTLE ACTUATOR STUCK OPEN):
| All of following conditions are met: | - |
| System guard* judge condition | ON |
| Throttle actuator current | 2 A or higher |
| Duty-cycle to close throttle | 80% or more |
P2112 (THROTTLE ACTUATOR STUCK CLOSED):
| All of following conditions are met: | - |
| System guard* judge condition | ON |
| Throttle actuator current | 2 A or higher |
| Duty-cycle to open throttle | 80% or more |
| *: System guard set when following conditions are met: | - |
| Throttle actuator | ON |
| Throttle actuator duty calculation | Executing |
| Throttle position sensor fail | Not detected |
| Throttle actuator current-cut operation | Not executing |
| Throttle actuator power supply | 4 V or higher |
| Throttle actuator fail | Not detected |