Rear Door Black Out Tape: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG . Refer to DISASSEMBLY - Step 1
REMOVE DOOR ASSIST GRIP COVER . Refer to DISASSEMBLY - Step 2
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY . Refer to DISASSEMBLY - Step 3
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP . Refer to DISASSEMBLY - Step 5
REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY . Refer to DISASSEMBLY - Step 7
REMOVE REAR DOOR SERVICE HOLE COVER . Refer to DISASSEMBLY - Step 9
REMOVE REAR DOOR GLASS RUN . Refer to DISASSEMBLY - Step 13
REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY . Refer to DISASSEMBLY - Step 15
REMOVE REAR DOOR QUARTER WINDOW GLASS . Refer to DISASSEMBLY - Step 16
REMOVE REAR DOOR GLASS SUB-ASSEMBLY . Refer to DISASSEMBLY - Step 17
REMOVE REAR DOOR WEATHERSTRIP See step 11
REMOVE REAR DOOR FRAME GARNISH . Refer to DISASSEMBLY - Step 14

REMOVE REAR DOOR OUTSIDE STRIPE

Using a heat light, heat the rear door outside stripe.

Heating temperature

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)

NOTE:

Do not heat the vehicle body excessively.

Pull back an edge of the rear door outside stripe and pull it parallel to the vehicle body to pull it off.

REMOVE REAR DOOR LOWER OUTSIDE STRIPE

Using a heat light, heat the rear door lower outside stripe.

Heating temperature

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)

NOTE:

Do not heat the vehicle body excessively.

Pull back an edge of the rear door lower outside stripe and pull it parallel to the vehicle body to pull it off.