DTC C1582: Assist Map Number Mismatch: Procedure

1. Check for DTCs. Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → See step   4 

A: Go to next step 

1. Check if any of the parts listed below have been replaced with an incorrect part in the past.

   Related Part	ECM
   	Main body ECU (multiplex network body ECU)
   	Brake actuator assembly (skid control ECU)

   NOTE:

   When removing a related part to check it, be sure to follow the appropriate procedures and precautions.

   • Refer to the following procedures to remove the ECM. Refer to REMOVAL .
   • Refer to the following procedures to remove the Main body ECU (multiplex network body ECU). Refer to REMOVAL .
   • Refer to the following procedures to remove the brake actuator assembly (skid control ECU). Refer to REMOVAL .

   HINT: 

   • DTC C1582 is stored when a part with an incorrect part number is installed for the related parts listed above.
   • When DTC C1582 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.
   RESULT
   
   

   Result	Proceed to
   All installed related parts have correct part number	A
   Part with incorrect part number is installed	B

B → REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER 

A → See step   3