Heated Oxygen Sensor: Installation: Installation

WARNING: This page is about a different car, the 2010 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HEATED OXYGEN SENSOR (for Bank 2)
1. Using SST, install the heated oxygen sensor.
  
  Fig 1: Identifying Heated Oxygen Sensor (For Bank 2)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09224-00010
  Torque: 44 N*m (449 kgf*cm, 32 ft.*lbf)
INSTALL HEATED OXYGEN SENSOR (for Bank 1)
1. Using SST, install the heated oxygen sensor.
  
  Fig 2: Identifying Heated Oxygen Sensor (For Bank 1)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09224-00010
INSTALL FRONT EXHAUST PIPE ASSEMBLY . Refer to INSTALLATION - Step 3
INSTALL ENGINE UNDER COVER LH
INSTALL ENGINE UNDER COVER RH