Installation (From 12/2010): Installation

INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
INSTALL INSTRUMENT PANEL WIRE ASSEMBLY
1. Connect the 2 connectors to the front passenger airbag assembly.
  NOTE:
  When handling the airbag connector, take care not to damage the airbag wire harness.
2. Install the clip.
INSTALL NO. 3 HEATER TO REGISTER DUCT . Refer to REASSEMBLY - Step 14
INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT . Refer to REASSEMBLY - Step 12
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY . Refer to INSTALLATION - Step 1
CONNECT INSTRUMENT PANEL WIRE ASSEMBLY
1. Connect the connector.
  
  Fig 1: Connecting Airbag Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  When handling the airbag connector, take care not to damage the airbag wire harness.
INSTALL TIRE PRESSURE MONITOR ECU
Refer to INSTALLATION - Step 3
INSPECT SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM