LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Matrix S, FWD, Automatic >> Repair and Diagnosis >> Restraints >> Passive Restraints >> Seat Belt >> Rear Seat Outer Belt Assembly >> Installation

Rear Seat Outer Belt Assembly: Installation

  1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY 
    1. Install the rear seat 3 point type belt assembly with the 2 bolts.

      Torque: Bolt <A> 

      4.9 N*m (50 kgf*cm, 43 in.*lbf) 

      Bolt <B> 

      41 N*m (420 kgf*cm, 30 ft.*lbf) 

      Fig 1: Identifying Rear Seat Point Type Belt Assembly With Bolts
      G06037391Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the shoulder anchor of the rear seat 3 point type belt assembly with the bolt.

      Torque: 41 N*m (420 kgf*cm, 30 ft.*lbf) 

    3. Check if the ELR locks.
      NOTE: The check should be performed with the outer belt assembly installed.
      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
      Fig 2: Identifying Shoulder Anchor Of Rear Seat Point Type Belt Assembly Bolt
      G06037389Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ROOF SIDE INNER GARNISH LH  (See INSTALLATION )
  3. INSTALL QUARTER PILLAR GARNISH LH  (See INSTALLATION )
  4. INSTALL SIDE DECK TRIM PANEL ASSEMBLY LH  (See INSTALLATION )
  5. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH  (See INSTALLATION )
  6. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side)  (See INSTALLATION )
  7. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side)  (See INSTALLATION )
  8. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH 
    1. Connect the floor anchor end of the rear seat 3 point type belt assembly LH and install the bolt.

      Torque: 41 N*m (420 kgf*cm, 30 ft.*lbf) 

      NOTE: Do not allow the anchor part of the rear seat 3 point type belt assembly LH to overlap the protruding part of the floor panel.
      Fig 3: Identifying Floor Anchor End Of Rear Seat Point Type Belt Assembly LH Bolt
      G06037393Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSTALL REAR SEAT SIDE GARNISH LH  (See INSTALLATION )
  10. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY (for LH Side)  (See INSTALLATION )
  11. INSTALL ROOF SIDE INNER GARNISH RH  (See INSTALLATION )
  12. INSTALL QUARTER PILLAR GARNISH RH  (See INSTALLATION )
  13. INSTALL SIDE DECK TRIM PANEL ASSEMBLY RH (w/o Woofer)  (See INSTALLATION )
  14. INSTALL SIDE DECK TRIM PANEL ASSEMBLY RH (w/Woofer)  (See INSTALLATION )
  15. INSTALL REAR COMBINATION LIGHT SERVICE COVER RH (w/ Woofer)  (See INSTALLATION )
  16. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side)  (See INSTALLATION )
  17. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for RH Side)  (See INSTALLATION )
  18. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH 
    1. Connect the floor anchor end of the rear seat 3 point type belt assembly RH and install the bolt.

      Torque: 41 N*m (420 kgf*cm, 30 ft.*lbf) 

      NOTE: Do not allow the anchor part of the rear seat 3 point type belt assembly RH to overlap the protruding part of the floor panel.
      Fig 4: Identifying Floor Anchor End Of Rear Seat Point Type Belt Assembly RH Bolt
      G06037394Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  19. INSTALL REAR SEAT SIDE GARNISH RH  (See INSTALLATION )
  20. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY (for RH Side)  (See INSTALLATION )
  21. INSTALL REAR DECK TRIM COVER  (See INSTALLATION )
  22. INSTALL LUGGAGE COMPARTMENT TRAY  (See INSTALLATION )
  23. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR (See  INSTALLATION  ) 
  24. INSTALL DECK FLOOR BOX RH  (See INSTALLATION )
  25. INSTALL DECK FLOOR BOX LH  (See INSTALLATION )
  26. INSTALL JACK ASSEMBLY  (See INSTALLATION )
  27. INSTALL JACK CARRIER ASSEMBLY 
  28. INSTALL NO. 2 DECK BOARD  (See INSTALLATION )
  29. INSTALL DECK BOARD ASSEMBLY  (See INSTALLATION )
  30. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 
  31. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH  (See INSTALLATION )
  32. INSTALL REAR DOOR SCUFF PLATE LH  (See INSTALLATION )
  33. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  34. INSTALL REAR DOOR SCUFF PLATE RH  (See INSTALLATION )
  35. INSTALL REAR SEAT CENTER OUTER BELT ASSEMBLY 
    1. Install the rear seat center outer belt assembly with the bolt.

    Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

  36. INSTALL REAR SEATBACK BOARD  (See REASSEMBLY )
    Fig 5: Identifying Rear Seat Center Outer Belt Assembly Bolt
    G06037386Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  37. INSTALL REAR SEAT SHOULDER BELT HOLE COVER 
    1. Engage the 2 claws and 2 guides to install the rear seat shoulder belt hole cover.
    Fig 6: Identifying Rear Seat Shoulder Belt Hole Cover Claws And Guides
    G06037385Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  38. INSTALL SEAT BELT ANCHOR COVER CAP 
    1. Engage the 2 claws to install the seat belt anchor cover cap.
  39. INSTALL REAR SEATBACK ASSEMBLY RH  (See INSTALLATION )
  40. INSTALL REAR SEATBACK INNER HINGE COVER (for RH Side)  (See INSTALLATION )
  41. INSTALL REAR SEATBACK OUTER HINGE COVER (for RH Side)  (See INSTALLATION )
    Fig 7: Identifying Seat Belt Anchor Cover Cap Claws
    G06037397Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  42. CONNECT REAR SEAT CENTER OUTER BELT ASSEMBLY 
    1. Install the rear seat center outer belt assembly and the rear seat inner belt assembly with the bolt.

      Torque: 41 N*m (420 kgf*cm, 30 ft.*lbf) 

      NOTE: Do not allow the anchor part of the rear seat center outer belt assembly and rear seat inner belt assembly to overlap the protruding part of the floor panel.
      Fig 8: Identifying Rear Seat Center Outer Belt Assembly Bolt
      G06037398Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  43. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY 
  44. INSTALL REAR SEAT HEADREST ASSEMBLY (for RH Side) 
  45. INSTALL REAR SEATBACK ASSEMBLY LH  (See INSTALLATION )
  46. INSTALL REAR SEATBACK INNER HINGE COVER (for LH Side)  (See INSTALLATION )
  47. INSTALL REAR SEATBACK OUTER HINGE COVER (for LH Side)  (See INSTALLATION )
  48. INSTALL REAR SEAT HEADREST ASSEMBLY (for LH Side) 
  49. INSTALL REAR SEAT CUSHION ASSEMBLY  (See INSTALLATION )
scientia non olet · About LEMON Manuals