Front Seat Outer Belt Assembly With PRETENSIONER: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
REMOVE FRONT DOOR SCUFF PLATE (See REMOVAL )
DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
REMOVE REAR DOOR SCUFF PLATE (See REMOVAL )
DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
REMOVE LAP BELT OUTER ANCHOR COVER (for Driver Side)
1. Disengage the 3 claws and remove the lap belt outer anchor cover.
Fig 1: Identifying Lap Belt Outer Anchor Cover Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE LAP BELT OUTER ANCHOR COVER (for Front Passenger Side)
1. Disengage the 2 claws as shown in the illustration.
  
  Fig 2: Identifying Lap Belt Outer Anchor Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disengage the 2 guides and remove the lap belt outer anchor cover.
Fig 3: Identifying Lap Belt Outer Anchor Cover And Guides
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH (for Driver Side)
1. Remove the bolt and disconnect the floor end of the front seat outer belt assembly LH.
REMOVE LOWER CENTER PILLAR GARNISH (See REMOVAL )

Fig 4: Identifying Front Seat Outer Belt Assembly LH Floor End Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH (for Front Passenger Side)
1. Disconnect the connector.
2. Disengage the clamp.
3. Remove the front seat belt anchor base and disconnect the floor end of the front seat outer belt assembly RH.
Fig 5: Identifying Front Seat Outer Belt Assembly RH Floor End Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE UPPER CENTER PILLAR GARNISH (See REMOVAL )
REMOVE FRONT SEAT OUTER BELT ASSEMBLY
1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
  
  Fig 6: Identifying Front Seat Outer Belt Assembly Shoulder Anchor Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver, pull out the locking button in the direction shown by the arrows to release the lock, and disconnect the pretensioner connector as shown in the illustration.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 7: Disconnecting Pretensioner Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. for Front Passenger Side:
  1. Disengage the clamp.
  Fig 8: Identifying Front Seat Outer Belt Assembly Connector Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 bolts and front seat outer belt assembly.
Fig 9: Identifying Front Seat Outer Belt Assembly And Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
1. Remove the 2 bolts and front shoulder belt anchor adjuster assembly.
Fig 10: Identifying Front Shoulder Belt Anchor Adjuster Assembly Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002