Brake Pedal: Removal

REMOVE FRONT DOOR SCUFF PLATE LH (See REMOVAL )
REMOVE COWL SIDE TRIM BOARD LH (See REMOVAL )
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (See REMOVAL )
REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (See REMOVAL )
REMOVE PUSH ROD PIN
1. Remove the clip and push rod pin from the brake pedal lever.
REMOVE STOP LIGHT SWITCH ASSEMBLY
1. Disconnect the stop light switch connector.
2. Remove the stop light switch (See REMOVAL ).
  
  Fig 1: Locating Push Rod Pin
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
1. Remove the brake pedal support reinforcement set bolt.
  
  Fig 2: Locating Brake Pedal Support Reinforcement Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 4 nuts and brake pedal support assembly.
  
  Fig 3: Locating Brake Pedal Support Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002