Transmission Wire: Installation

INSTALL TRANSMISSION WIRE
1. Coat a new O-ring of the transmission wire connector with ATF and install it.
  
  Fig 1: Identifying O-Ring Of Transmission Wire Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the transmission wire with the bolt.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 2: Locating Transmission Wire Connector Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION WIRE
1. Coat a new O-ring of the ATF temperature sensor with ATF.
2. Install the ATF temperature sensor with the lock plate and bolt.
  Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf)
3. Connect the 7 shift solenoid valve connectors.
  
  Fig 3: Locating Shift Solenoid Valve Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
1. Install the 2 magnets in the oil pan.
2. Apply adhesive to the 18 bolts.
  Adhesive: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
  
  Fig 4: Identifying Magnets From Oil Pan
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a new gasket, install the oil pan to the transaxle case with the 18 bolts.
  Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf)
  
  NOTE: Apply adhesive to the bolts and tighten them within 10 minutes of application.
INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
HINT:

(See INSTALLATION )

Fig 5: Locating Oil Pan Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
ADD AUTOMATIC TRANSAXLE FLUID
INSPECT AUTOMATIC TRANSAXLE FLUID (See ON-VEHICLE INSPECTION )
INSPECT FOR TRANSAXLE FLUID LEAK
INSTALL NO. 2 ENGINE UNDER COVER (See INSTALLATION )
INSTALL NO. 1 ENGINE UNDER COVER (See INSTALLATION )
INSTALL ENGINE UNDER COVER ASSEMBLY (See INSTALLATION )
RESET MEMORY
HINT:

(See INITIALIZATION )