REAR STABILIZER BAR (for 4WD): Removal
- REMOVE DECK BOARD ASSEMBLY (See REMOVAL )
- REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Tonneau Cover) (See REMOVAL )
- REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Tonneau Cover) (See REMOVAL )
- REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) (See REMOVAL )
- REMOVE REAR MAT (See REMOVAL )
- REMOVE DECK TRIM SERVICE HOLE COVER
- REMOVE LOWER SPARE WHEEL CARRIER HINGE COVER (w/ Cover)
- REMOVE SPARE TIRE
- REMOVE SPARE WHEEL CARRIER LOCK COVER (w/ Cover)
- REMOVE REAR WHEELS
- REMOVE TAIL EXHAUST PIPE ASSEMBLY (See INSTALLATION )
- REMOVE REAR STABILIZER LINK ASSEMBLY LH
- Remove the nut and separate the rear stabilizer link assembly LH from the rear stabilizer bar.
HINT:
If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.
- Remove the nut and the rear stabilizer link assembly LH from the rear shock absorber with coil spring LH.
HINT:
If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.
- Remove the nut and separate the rear stabilizer link assembly LH from the rear stabilizer bar.
- REMOVE REAR STABILIZER LINK ASSEMBLY RH
HINT:
Perform the same procedure as the LH side.
- REMOVE REAR STABILIZER BAR BRACKET LH (for Rear Side)
- Remove the 2 bolts and the rear stabilizer bar bracket LH (rear side).
- REMOVE REAR STABILIZER BAR BRACKET RH (for Rear Side)
- Remove the 2 bolts and the rear stabilizer bar bracket RH (rear side).
- REMOVE REAR STABILIZER BUSHING (for LH Side)
- Remove the rear stabilizer bushing (LH side).
- REMOVE REAR STABILIZER BUSHING (for RH Side)
- Remove the rear stabilizer bushing (RH side).
- REMOVE REAR STABILIZER BAR BRACKET LH (for Front Side)
- Remove the bolt and the rear stabilizer bar bracket LH (front side).
- REMOVE REAR STABILIZER BAR BRACKET RH (for Front Side)
- Remove the 2 bolts and the rear stabilizer bar bracket RH (front side).
- REMOVE REAR STABILIZER BAR