Rear Strut Rod: Installation

TEMPORARILY INSTALL REAR STRUT ROD ASSEMBLY (for 2WD)
1. Check that the identification mark of the rear strut rod assembly is positioned on the inner side of the vehicle.
2. Temporarily install the rear strut rod assembly with the 2 bolts and the 2 nuts.
  NOTE: Since stopper nuts are used, temporarily tighten the bolts.
Fig 1: Identifying Mark Of Rear Strut Rod Assembly (2WD)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEMPORARILY INSTALL REAR STRUT ROD ASSEMBLY (for 4WD)
1. Check that the identification mark of the rear strut rod assembly is positioned on the inner side of the vehicle.
2. Temporarily install the rear strut rod assembly with the 2 bolts and the 2 nuts.
  NOTE: Since stopper nuts are used, temporarily tighten the bolts.
Fig 2: Identifying Mark Of Rear Strut Rod Assembly (4WD)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
STABILIZE SUSPENSION (for 2WD) (See INSTALLATION )
STABILIZE SUSPENSION (for 4WD) (See REAR STRUT ROD )
FULLY TIGHTEN REAR STRUT ROD ASSEMBLY (for 2WD)
1. Fully tighten the 2 bolts.
  Torque: 80 N*m (815 kgf*cm, 59 ft.*lbf)
  NOTE:
  - Since stopper nuts are used, fully tighten the bolts.
  - The final torque must be applied under standard vehicle height conditions.
  Fig 3: Locating Rear Strut Rod Assembly (2WD) Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FULLY TIGHTEN REAR STRUT ROD ASSEMBLY (for 4WD)
1. Fully tighten the bolt.
  Torque: 80 N*m (815 kgf*cm, 59 ft.*lbf)
  NOTE:
  - Since a stopper nut is used, fully tighten the bolt.
  - The final torque must be applied under standard vehicle height conditions.
  Fig 4: Locating Rear Strut Rod Assembly (4WD) Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the bolt.
  Torque: 80 N*m (815 kgf*cm, 59 ft.*lbf)
  NOTE:
  - Since a stopper nut is used, fully tighten the bolt.
  - The final torque must be applied under standard vehicle height conditions.
  Fig 5: Locating Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
1. Install the No. 3 parking brake cable assembly with the bolt and the nut.
  Torque: Bolt
  
  39 N*m (397 kgf*cm, 29 ft.*lbf)
  
  Nut
  
  6.0 N*m (61 kgf*cm, 53 in.*lbf)
  
  NOTE: Do not twist the No. 3 parking brake cable assembly when installing it.
  
  Fig 6: Locating No. 3 Parking Brake Cable Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)