Front Seat Outer Belt Assembly With PRETENSIONER: Installation

INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
1. Engage the adjuster positioning hole with the claw and install the front shoulder belt anchor adjuster assembly with the 2 bolts.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 1: Identifying Front Shoulder Belt Anchor Adjuster Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT SEAT OUTER BELT ASSEMBLY
1. Temporarily install the front seat outer belt assembly with the 2 bolts.
2. Fully tighten the bolt < A > first, then the bolt < B > to install the front seat outer belt assembly.
  Torque: Bolt < A >
  
  7.5 N*m (77 kgf*cm, 66 in.*lbf)
  
  Bolt < B >
  
  42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 2: Identifying Front Seat Outer Belt Assembly With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector and lock the locking button as shown in the illustration.
  NOTE: Securely lock the locking button.
  
  Fig 3: Connecting Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the shoulder anchor of the front seat outer belt assembly with the nut.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
INSTALL CENTER PILLAR GARNISH (See INSTALLATION )

Fig 4: Identifying Front Seat Outer Belt Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FRONT SEAT OUTER BELT ASSEMBLY
1. Install the floor end of the front seat outer belt assembly with the bolt.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
2. Check if the ELR locks.
  NOTE: The check should be performed with the outer belt assembly installed.
  1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
    
    Fig 5: Identifying Floor End Of Front Seat Outer Belt Assembly
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER CENTER PILLAR GARNISH (See INSTALLATION )
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP (See INSTALLATION )
INSTALL REAR DOOR SCUFF PLATE (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )