LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Except Hybrid) >> Seat Position Sensor >> Installation

Seat Position Sensor: Installation

  1. INSTALL SEAT POSITION SENSOR 
    1. Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.
      Fig 1: Installing Seat Position Sensor
      G05419386Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 1.3 mm (0.051 in.) feeler gauge, temporarily install the seat position sensor.
      NOTE:
      • If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
      • When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
      Fig 2: Installing Seat Position Sensor And Using Feeler Gauge
      G05419387Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.024 in.) to 2.0 mm (0.079 in.).

    3. Using a "TORX" socket wrench (T30), tighten the "TORX" screw to install the seat position sensor.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

    4. Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.024 in.) to 2.0 mm (0.079 in.).
    5. Connect the connector.
    6. Check that there are no loose parts after installing the seat position sensor.
  2. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat)  (See INSTALLATION )
  3. INSPECT FRONT SEAT SLIDE ADJUSTER LOCK (for Manual Seat)  (See INSTALLATION )
  4. INSTALL REAR SEAT TRACK COVER LH (for Manual Seat)  (See INSTALLATION )
  5. INSTALL FRONT INNER SEAT TRACK COVER LH (for Manual Seat)  (See INSTALLATION )
    Fig 3: Locating "TORX" Screw And Seat Position Sensor
    G05419384Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL FRONT OUTER SEAT TRACK COVER LH (for Manual Seat)  (See INSTALLATION )
  7. INSTALL FRONT SEAT HEADREST ASSEMBLY LH (for Manual Seat)  (See INSTALLATION )
  8. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat)  (See INSTALLATION )
  9. INSTALL REAR INNER SEAT TRACK COVER LH (for Power Seat)  (See INSTALLATION )
  10. INSTALL REAR OUTER SEAT TRACK COVER LH (for Power Seat)  (See INSTALLATION )
  11. INSTALL FRONT INNER SEAT TRACK COVER LH (for Power Seat)  (See INSTALLATION )
  12. INSTALL FRONT OUTER SEAT TRACK COVER LH (for Power Seat)  (See INSTALLATION )
  13. INSTALL FRONT SEAT HEADREST ASSEMBLY LH (for Power Seat)  (See INSTALLATION )
  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Manual Seat) 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  15. INSPECT FRONT SEAT ASSEMBLY (for Power Seat)  (See INSTALLATION )
  16. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals