FRONT SEAT ASSEMBLY (for Power Seat): Installation

1. Place the front seat assembly in the cabin.
   NOTE: Be careful not to damage the vehicle body.
2. Connect the connectors under the seat.
3. Connect the cable to the negative (-) battery terminal.
   NOTE: When reconnected the cable, some systems need to be initialized (See INITIALIZATION ).
   Fig 1: Identifying Reclining Power Seat Switch Knob And Claws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Temporarily install the front seat assembly with the 4 bolts.
5. Operate the power seat switch knob and move the seat to the rearmost position.
6. Tighten the 2 bolts on the front side of the seat.

   Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

   HINT:

   Tighten the bolts in the order indicated in the illustration.

7. Operate the power seat switch knob and move the seat to the foremost position.
   Fig 2: Identifying Front Seat Assembly With Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Tighten the 2 bolts on the rear side of the seat.

   Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

   HINT:

   Tighten the bolts in the order indicated in the illustration.

   Fig 3: Identifying Front Seat Assembly With Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Engage the 2 claws and install the rear inner seat track cover.

Fig 4: Identifying Rear Inner Seat Track Cover And Claws

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Engage the 2 claws and install the rear outer seat track cover.

1. Operate the power seat switch knob and move the seat to the rearmost position.
   Fig 5: Identifying Rear Outer Seat Track Cover And Claws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 2 claws and install the front inner seat track cover.

Fig 6: Installing Front Inner Seat Track Cover And Claws

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Engage the 2 claws and install the front outer seat track cover.

Fig 7: Identifying Front Outer Seat Track Cover And Claws

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the front seat headrest assembly as shown in the illustration.

1. Inspect the power seat operation.
2. w/ Seat Heater System: Check the seat heater operation.
   1. Turn the ignition switch on (IG).
   2. Turn the seat heater switch on.
   3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

(See DIAGNOSIS SYSTEM )

Fig 8: Installing Front Seat Headrest Assembly

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002